Front End Panels

After installing the duct panel the shape was returning to the panels on either side of the grill opening.

But before continuing with panel straightening , repairs need to be made to some small cracks on the bottom right (passenger) of the grill opening.

The metal here is quite thin. Using a piece of copper to act as a heat sink and helps reduces the risk of blowing holes through the metal. Drilling a small hole at the ends of the cracks helps prevent the cracks from growing. I was quite nervous welding on an outer panel (even though it will be cover by the grill). 

*************************************************************

This gives some strength back to the panel  and now the beatings can begin!

Actually the panels didn't need all that much persuasion with the slapper to get a proper look.

Final shape will be made when the actual grill that will be going on the car  is available (this one will be replaced by a higher quality one).

The front end is actually starting to look like an MGA!